KNX Software
Plan KNX without an ETS license
Assign and manage group addresses, configure KNX actuators, ETS-compatible XML export. Right in the browser, nothing to install.
Problems
KNX planning doesn't have to be expensive
You don't need an ETS license per project. Especially not during planning.
ETS is expensive
Several hundred euros per license, hard to scale across multiple staff.
Group addresses get messy
Manually assigned addresses become chaotic. No consistent logic across the team.
No link to the installation
ETS doesn't know your installation plan. Double maintenance is the result.
How it works
KNX in three steps
From symbol placement to ETS import.
- 1
Tag symbols
Mark KNX-capable components in the installation plan as bus participants.
- 2
Assign group addresses
Automatic suggestions following main / middle / sub group. Override manually anywhere.
- 3
Export to ETS
Generate an ETS-compatible XML export and import it into ETS. Commissioning stays in the tool you know.
Features
Everything for the KNX planning phase
Complements ETS, doesn't replace it. Exactly where it gets expensive.
Group address management
Structured address model with main, middle and sub groups. Conflicts detected automatically.
ETS-compatible XML export
Addresses, participants and structures as XML for ETS import. No double entry.
Visual bus topology
Lines and areas with attached participants at a glance. Cable runs visible on the plan.
Integrated in the plan
KNX data lives on the same symbol as the installation plan. One source, no break.
Actuator templates
Pick actuator types from a library, channels filled automatically. Configuration in seconds.
Multiple editors
Same project, multiple editors. No license per seat, just one team plan.
KNX in the full project
KNX addresses are linked with:
FAQ
Frequently asked questions
Ready for efficient electrical planning?
Stop entering data multiple times. Installation plans, circuit diagrams, parts lists, and more – all automatic. Start free today.